Ro Water Filter Tank Pressure

If it s lower than that add more pressure using a bicycle pump up to 5 psi.

Ro water filter tank pressure.

Most standard reverse osmosis tanks are three to four gallon tanks that work best when the pressure in them is between six and ten pounds per square inch psi so the magic number that we are shooting for is eight pounds of pressure. Additionally production is reduced whenever the water temperature is below 77 f. Most ro units have an automatic water shutoff that kicks in when the pressure inside the tank reaches 2 3 of the pressure of the water flowing from your main line into the ro system. Point y on figure 1.

Use an air pressure gauge to check the current air pressure. Close the tank s ball valve. Locate the pressure valve under the blue cap on the tank. Using a pressure gauge check the air pressure in the tank.

It should be around 5 psi for a standard 4 gallon tank 3 2 gallon capacity. You have to empty the tank of water in order to check the air pressure. You can find these at auto parts stores or hardware stores. Use air compressor or bicycle pump to re pressurize the 4 gallon tank to 5 psi and 7psi for the 14 gallon tank.

If the water pressure feeding an ro system is less than that the system will produce less water and at a lower quality. Disconnect the yellow line from the tank valve. Drain the old tank completely thru the spigot. Your tank should have pressure of 7 to 8 psi without any water in the tank.

Open the cap at the bottom of the tank to access the pressure valve. You might have low air pressure inside the ro tank itself. The standard air charge for undersink ro tanks is about seven psi when there is no water in the tank. Turn off the feed water supply to the ro.

Private well systems most commonly have pressurized storage tank and pump systems with 20 40 psi or 30 50 psi on off pressure settings. The reverse osmosis system is equipped with a sensory valve that halts the production of water when the pressure in the tank reaches 2 3 of the line pressure. In the pnrv18 model the tank holds approximately 1 5 gallons and in the pnrv model it holds 2 1 gallons. It takes 4 hours to produce 2 gallons of water.

Reconnect the yellow line at point y. The water pressure decreases as the tank gets near empty since the reverse osmosis filter produces water at a slow rate. To check the pressure accurately you need a low pressure air gauge. To check your pressure locate the schrader valve typically covered by a blue plastic cap on the side of the tank near the bottom.