Painting Cedar Shake Sidings Seven Lakes Nc

All done by hand to ensure full coverage.

Painting cedar shake sidings seven lakes nc.

How to prepare old cedar shakes for repainting. Pour the paint into a five gallon bucket. Properly primed a 100 percent acrylic latex paint will provide decades of protection for cedar siding shingles. While extremely old cedar can be painted it requires heavy preparation.

See the difference our team made in painting cedar shake siding to restore this house in phillipsburg nj. See how the pros sand prep prime and paint a cedar shingle home. Loosened photodegraded surface fibers and any loosened remaining finish must be removed prior to re finishing. Even then the paint is not expected to last long.

Be careful when painting very old cedar siding. Remove as much of the old paint as possible as the more prep work you do. Powerwash the siding to remove any excess dirt or paint with a low pressure pressure washer. The gap between the shakes acts like a miniature funnel in a driving rainstorm.

A step by step guide to walk you through the pro. The siding must be free from mold mildew and dirt. These paints form a tough but flexible film that allows moisture within the wood to escape while protecting the cedar from atmospheric moisture that might lead to extractive bleed. This is necessary if for example the old finish is severely cracked or is peeling.

The original cedar shake siding was faded and disc. In refinishing painted or solid color stained siding and trim removal of the old coating may be required. Painting bare cedar shakes that are already installed is very hard and can lead to other pesky problems down the road. One of the issues of painting cedar shakes after they are installed is that you don t get paint on critical parts of the shakes that can get wet.

If possible stain all sides of the siding before installation. Stains dry rapidly and fresh stain applied over dried stain will show lap marks. First remove any mill glaze a hard shiny surface on one side of the siding by sanding. Remove the shake and hold it over the bucket while wiping off the excess with a paint brush.

Hang the shakes from a clothesline while they dry. Next dip each shake into the paint leaving only an inch or two not painted at the top where it is being held. Scrape any peeling paint chips off the shakes with a scraper.